Okay, my shop is still so cluttered up I can't get to the bench and use my lathe like I do for a prep station. I put my thinking cap on and bolted an old Sears drill press stand to a board. I cut a hole in the board slightly bigger than my case trimmer. I chucked up the case trimmer and my old drill. A zip tie on the trigger is fully adjustable for speed and I clamped it all down on my reloading desk. I first ran the Tri-way cutter and cut 1000 pieces of brass to length then I chucked up the primer pocket cutter and did all the pockets. The cutter tool sits recessed in the board so you don't catch yourself on it and it directs the chip of brass downward into a box on the floor.
Here is the Tri-way......not a bad set up if I do say so myself.